1 3

Vastex

PTF-100 DTF Powder-To-Film Applicator

PTF-100 DTF Powder-To-Film Applicator - 110 V

SKU:

$3,260.00 CAD
$3,260.00 CAD
Vente Épuisé
Frais d'expédition calculés à l'étape de paiement.

The Vastex PTF-100 DTF Powder-to-Film system uniformly coats DTF films with adhesive powder, without dusting and spillage. This reduces waste while improving DTF printing performance and operator safety. 


To operate, a filled cartridge is inserted at the top of the unit, and an empty cartridge at the bottom. An operator positions the wet DTF printed film on the application tray, print side up. Once the polycarbonate door is closed tightly, the operator can adjust the angle of the powder deflector and the amount of powder to be released.


With each cycle, the user pulls a lever to release the desired amount of powder, then pushes it to start the timer/vibration. The top cartridge releases adhesive powder which rains down on the film, ensuring complete and even coverage. When empty, the upper cartridge can be switched quickly and cleanly with the lower cartridge containing all excess powder, reducing exposure while eliminating waste and allowing continuous production until refilling is needed.


Features:

  • Fits up to 16" x 20" film sheets
  • Adjustable timer
  • Sealed for mess-free operation
  • Interchangeable cartridges for quick and clean refills.


*Lead times vary based on stock availability

    Volts
    • Special Order
    disabled
    This product is typically ready for pickup or shipping within one week, subject to lead times provided by manufacturers.
    The PTF-100 DTF Powder-To-Film Applicator is a special order product that is sourced specifically for you after you place your order. Please note that it may take up to one week for the product to be ready for pickup or shipment, depending on the lead times provided by the manufacturer. After your purchase, we will contact you to confirm the estimated lead times.

    Product Resources

    Afficher tous les détails

    Additional Information

    Below are recommended settings for curing DTF sheets. Testing was done on RB Onyx DTF film and powder. And RB Vibra DTF ink. (Note: these settings are to be used as a starting point. Settings may vary depending on which DTF film, powder and ink is used)

     

    After powder is applied, place your printed DTF sheet on the Vastex D-100 conveyor dryer (Allow to fully heat up for approximately 10-15 min)

    • Set heat at 5.5
    • Set belt speed at 15 - Media takes about 2.5 min to go through
    • You will have good results with Exhaust on or off

    Cutter

    • Voltage: 110V
    • Max Media Width: 16 to 20 in sheets
    • Shipping Dimensions: 30" x 25" x 39"
    • Shipping Weight: 140 lbs
    • Machine Dimensions: 31"(H) x 23.5"(W) x 23"(L)
    • Machine Weight: 70 lbs

    1 Year Warranty